Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum - Search Results
Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum
Showing results 1 to 25 of 500
Search took 0.19 seconds.
Search: Posts Made By: scottl1346
Forum: Foreman 500 Today, 01:53 PM
Replies: 53
Views: 3,367
Posted By scottl1346
Just got my kit installed. Doesn't seem to stop...

Just got my kit installed. Doesn't seem to stop good it stops but it's a slow roll stop. The cam on the caliper doesn't seen to reset like on the old drums. Anyone having any issues like this??
Forum: Foreman 450 Yesterday, 08:35 PM
Replies: 4
Views: 59
Posted By scottl1346
i dont know every machine is different id order...

i dont know every machine is different id order 138 140 and 142
Forum: Foreman 450 Yesterday, 08:23 PM
Replies: 4
Views: 59
Posted By scottl1346
i would try the next 3 sizes up from 135 id start...

i would try the next 3 sizes up from 135 id start with the richest and work my way lean. your pilot should be good
Forum: Foreman 500 10-28-2014, 10:39 PM
Replies: 5
Views: 157
Posted By scottl1346
no rebuild kit but that would be a good idea. i...

no rebuild kit but that would be a good idea. i also order from Honda east have been for yrs great prices and free shopping over 100 bucks.
if your doing bearings freeze them for a few hours then...
Forum: Off Topic 10-28-2014, 10:34 PM
Replies: 15
Views: 244
Posted By scottl1346
why not sell the big trailer and buy a bigger...

why not sell the big trailer and buy a bigger trailer?
Forum: New Member Intros 10-28-2014, 10:31 PM
Replies: 7
Views: 125
Posted By scottl1346
welcome to the forum.

welcome to the forum.
Forum: Foreman 450 10-28-2014, 10:30 PM
Replies: 4
Views: 108
Posted By scottl1346
you can run without it but im one of those guys...

you can run without it but im one of those guys that thinks it was put in there for a reason so id put it back in lol but it will work fine without
Forum: Foreman 500 10-15-2014, 10:59 PM
Replies: 6
Views: 924
Posted By scottl1346
highlifter has them for 150.00 plus a 60.00 core...

highlifter has them for 150.00 plus a 60.00 core once you send it in you'll get 60 back and if you add something to your cart and leave it there after a few days they will send you a 10% off email to...
Forum: Foreman 450 09-29-2014, 07:02 PM
Replies: 23
Views: 8,611
Posted By scottl1346
take it apart and clean the float needle its...

take it apart and clean the float needle its stuck open allowing fuel to keep flowing. might be worth looking into a carb rebuild kit
Forum: Foreman 400 09-29-2014, 06:55 PM
Replies: 8
Views: 401
Posted By scottl1346
if its sparking after you release the button it...

if its sparking after you release the button it could be the regulator-rectifier is bad
Forum: Foreman 500 09-28-2014, 02:17 PM
Replies: 3
Views: 153
Posted By scottl1346
oops just noticed this is for a 500. i was...

oops just noticed this is for a 500. i was talking about a 450 not sure how different they are never done any work on a 500.
heres a list of service manuals just find your machine and download...
Forum: Foreman 500 09-28-2014, 02:12 PM
Replies: 3
Views: 153
Posted By scottl1346
i doubt its a cam chain issue. if the tensioner...

i doubt its a cam chain issue. if the tensioner goes bad it will rattle/slap all the time.
the chain and tensioner are under the front cover. best to drain the oil and tilt it on its rear rack. the...
Forum: Foreman 450 09-25-2014, 10:33 PM
Replies: 7
Views: 190
Posted By scottl1346
check for play in them should be none

check for play in them should be none
Forum: Foreman 450 09-24-2014, 10:05 AM
Replies: 7
Views: 183
Posted By scottl1346
iv never herd of the drum seal squeaking be for....

iv never herd of the drum seal squeaking be for. are you sure you don't have a bearing that's going out?
look into the bel-ray water proof grease iv tried the marine grease and it still washed out...
Forum: Foreman 450 09-23-2014, 07:16 PM
Replies: 7
Views: 183
Posted By scottl1346
your supposed to use a waterproof grease on the...

your supposed to use a waterproof grease on the seals running them dry wont do anything just shorten the life of them. . .
Forum: Rubicon 500 09-17-2014, 11:09 PM
Replies: 9
Views: 231
Posted By scottl1346
bel-ray water proof grease. check the steering...

bel-ray water proof grease. check the steering stem bushing could also be tie rod ends, ball joints.
Forum: Rubicon 500 09-16-2014, 11:03 PM
Replies: 4
Views: 207
Posted By scottl1346
there's 2 test one with decompression effected...

there's 2 test one with decompression effected and the other is with the decompression not effected. there's not a wet test usually thats only done to confirm you have bad rings. when doing a...
Forum: Foreman 450 09-14-2014, 10:21 PM
Replies: 4
Views: 247
Posted By scottl1346
they are fine but cost the same as ordering a new...

they are fine but cost the same as ordering a new cylinder from honda east taledo once you have it bored out. i started a thread here on them just do a search
Forum: Foreman 450 09-13-2014, 05:09 PM
Replies: 2
Views: 191
Posted By scottl1346
OEM there cheap about 17 per joint honda east...

OEM there cheap about 17 per joint
honda east teledo is the cheapest around free shipping over 100$
Forum: Foreman 450 09-10-2014, 09:05 PM
Replies: 14
Views: 441
Posted By scottl1346
kinda sounds like the SE valve (choke) is on is...

kinda sounds like the SE valve (choke) is on is it seating fully?
Forum: Foreman 400 09-09-2014, 02:39 PM
Replies: 8
Views: 401
Posted By scottl1346
welcome to the forum. check your gas cap vent...

welcome to the forum.
check your gas cap vent it should be free flowing.
Forum: Foreman 500 09-08-2014, 04:26 PM
Replies: 6
Views: 924
Posted By scottl1346
doesn't the after market web cam come without the...

doesn't the after market web cam come without the de compression lever? might be cheaper to go that rout?
Forum: Foreman 450 09-06-2014, 11:34 PM
Replies: 11
Views: 308
Posted By scottl1346
gotta turn the fuel off when trailering

gotta turn the fuel off when trailering
Forum: Foreman 450 08-31-2014, 11:40 PM
Replies: 6
Views: 158
Posted By scottl1346
i use the tusk gasket kit off e-bay under 25...

i use the tusk gasket kit off e-bay under 25 bucks works great comes with all top end gaskets
Forum: Foreman 500 08-29-2014, 12:29 PM
Replies: 12
Views: 527
Posted By scottl1346
spacers!! flipping them will mess the wheel up...

spacers!! flipping them will mess the wheel up overtime and it looks ugly
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 04:39 PM.




Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0