Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum - Search Results
Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum
Showing results 1 to 25 of 500
Search took 0.17 seconds.
Search: Posts Made By: scottl1346
Forum: Foreman 500 Today, 05:14 PM
Replies: 10
Views: 184
Posted By scottl1346
depends on how much moisture is in there it can...

depends on how much moisture is in there it can be a lot or a little mine does it a good amount until its warmed up outside temp also plays a factor. put your hand over the exhaust it will turn to...
Forum: Foreman 500 Yesterday, 11:47 PM
Replies: 19
Views: 220
Posted By scottl1346
it has a vent already on it you just need to...

it has a vent already on it you just need to extend it
Forum: Foreman 500 Yesterday, 10:28 PM
Replies: 5
Views: 69
Posted By scottl1346
no room under the seat?

no room under the seat?
Forum: Foreman 500 Yesterday, 10:26 PM
Replies: 19
Views: 220
Posted By scottl1346
should be carb front and rear diff rear drum...

should be carb front and rear diff rear drum brake and fan
Forum: Foreman 450 Yesterday, 02:07 PM
Replies: 3
Views: 59
Posted By scottl1346
welcome to the forum. when the last time it was...

welcome to the forum.
when the last time it was cleaned or rebuilt?
Forum: Foreman 500 04-21-2014, 09:55 PM
Replies: 19
Views: 220
Posted By scottl1346
take a piece with you but i believe its like 1/4"...

take a piece with you but i believe its like 1/4" or 3/16"
Forum: Foreman 500 04-21-2014, 09:46 PM
Replies: 6
Views: 119
Posted By scottl1346
the connection is behind the right wheel...

the connection is behind the right wheel connected to the frame not in the battery box a quick test of the fan controller and fan is to disconnect that wire its either a blue or greenish color its a...
Forum: Rubicon 500 04-21-2014, 09:32 PM
Replies: 14
Views: 173
Posted By scottl1346
click go advance, scroll down click manage...

click go advance, scroll down click manage attachments, click browse find your pic, click open then hit upload
Forum: Foreman 450 04-21-2014, 03:09 PM
Replies: 8
Views: 155
Posted By scottl1346
no prob. best way to do it is to drain the oil...

no prob. best way to do it is to drain the oil and tilt the wheeler on its back back its 100x easier to work on that way. while your in there id take a good look at the shift plate very common to...
Forum: Foreman 500 04-21-2014, 12:21 PM
Replies: 16
Views: 202
Posted By scottl1346
you'll buy 28's and wish you went 29.5's at least...

you'll buy 28's and wish you went 29.5's at least that my issue after buying 27" but i was worried about weight
Forum: Foreman 450 04-21-2014, 12:17 PM
Replies: 8
Views: 155
Posted By scottl1346
free service manuals if you don't have 1 already....

free service manuals if you don't have 1 already.
Service Manual Downloads - All years - Honda ATV Forum...
Forum: Foreman 450 04-21-2014, 12:16 PM
Replies: 8
Views: 155
Posted By scottl1346
oneway bearing is bad. personally id change it...

oneway bearing is bad. personally id change it these foreman dont have great brakes to begin with so anything helps. i don't know what damage would be caused if any but its there for a reason.
its...
Forum: Foreman 450 04-21-2014, 11:30 AM
Replies: 8
Views: 155
Posted By scottl1346
sounds like the one way bearing is gone. do you...

sounds like the one way bearing is gone. do you still have engine braking when you go down a hill?
Forum: Foreman 500 04-20-2014, 04:38 PM
Replies: 6
Views: 119
Posted By scottl1346
bottom of the motor in the rear should be 1 wire...

bottom of the motor in the rear should be 1 wire going to it
Forum: Foreman 400 04-19-2014, 07:03 PM
Replies: 12
Views: 164
Posted By scottl1346
pull the dust seal off that bearing and add some...

pull the dust seal off that bearing and add some grease and press the seal back in that will keep it going even longer
Forum: Foreman 450 04-19-2014, 05:35 PM
Replies: 11
Views: 182
Posted By scottl1346
might feel tight but did you check to make sure...

might feel tight but did you check to make sure it was greased and not dried out
Forum: Foreman 450 04-19-2014, 01:33 PM
Replies: 11
Views: 182
Posted By scottl1346
sounds like a bad front wheel bearing

sounds like a bad front wheel bearing
Forum: Foreman 500 04-18-2014, 11:56 PM
Replies: 2
Views: 101
Posted By scottl1346
they should tighten up maybe stripped?

they should tighten up maybe stripped?
Forum: Foreman 450 04-18-2014, 10:07 PM
Replies: 8
Views: 153
Posted By scottl1346
check the bleeders on the calipers make sure they...

check the bleeders on the calipers make sure they are facing up other wise you'll never bleed all the air out of them
Forum: Foreman 500 04-18-2014, 01:37 PM
Replies: 16
Views: 378
Posted By scottl1346
pretty sure the idle is controlled by the...

pretty sure the idle is controlled by the computer and isn't adjustable so your only option is to build a exhaust snorkel or try tightening the throttle cable adjustment
Forum: Foreman 500 04-18-2014, 09:12 AM
Replies: 16
Views: 378
Posted By scottl1346
2 options build yourself a exhaust snorkel or...

2 options build yourself a exhaust snorkel or turn the idle up but remember to turn it down when your not in water
Forum: Foreman 500 04-17-2014, 07:47 PM
Replies: 10
Views: 184
Posted By scottl1346
is it liquid cooled? could be a bad head gasket...

is it liquid cooled? could be a bad head gasket leaking coolant into the cylinder.
does the white smoke go away after it warms up?
Forum: Foreman 500 04-17-2014, 05:20 PM
Replies: 5
Views: 112
Posted By scottl1346
you only need 1 thread questions sometimes don't...

you only need 1 thread questions sometimes don't get answered right away multiple threads wont speed up the process. i answered you questions in you other thread its more then likely just...
Forum: Foreman 500 04-17-2014, 05:16 PM
Replies: 10
Views: 184
Posted By scottl1346
white smoke is condensation from the exhaust...

white smoke is condensation from the exhaust being under water it will go away when it dries out.
Forum: New Member Intros 04-17-2014, 12:55 PM
Replies: 4
Views: 70
Posted By scottl1346
welcome to the forum

welcome to the forum
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -4. The time now is 06:33 PM.




Powered by vBulletin® Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0