Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum - View Profile: hughesnp
Honda Foreman Forums : Rubicon, Rincon, Rancher and Recon Forum

hughesnp hughesnp is offline

Honda Lover

Visitor Messages

Showing Visitor Messages 1 to 4 of 4
  1. hughesnp
    07-04-2012 10:57 PM - permalink
    there's about 1/4 inch between the bearing and the seal closest to the bearing, I never took the bearing out because it didn't seem to need replacing, no hanging up or popping or anything
  2. rich450es
    07-04-2012 10:47 PM - permalink
    the bearing isnt pushed all the way in the tube is it ?
  3. hughesnp
    06-20-2012 11:08 PM - permalink
    I feel yah on the never wanting to fix it again, I feel the same way, I will go ahead and I will go ahead and put the S pattern in my brake cam while I got it off, rear axle came in today, so I'm about ready to put it all back together n get back to riding, thanks man
  4. rich450es
    06-20-2012 10:46 PM - permalink
    i drilled and tapped into the aluminum backing plate . i just tore mine apart last week (water in rear drum ) and i had plenty of grease on the cam but i grooved it on the grinding wheel (like a s pattern ) to get even more grease on the cam !!!! i never want to fix anuther seized honda rear brake cam again

About Me

  • About hughesnp
    Ware Shoals, SC
    Trail riding
  • Signature
    2007 Honda Foreman 500 4x4
    K&N Air Filter
    Carb Mod

    2013 Yamaha Raptor 700R
    GYTR/FMF Exhaust
    GYTR Plastic Frame Glide Plate
    GYTR Sport Front Grab Bar
    GYTR Nerf Bars
    GYTR Aluminum Footwells
    GYTR Timing Plugs (Blue)
    GYTR Oil Fill Cap (Blue)
    Maxxis Razr Xc Tires
    OMF Wheels
    Pro Taper SE Handlebars
    Pro Taper Dual Density Grips


Total Posts
Visitor Messages
General Information
  • Last Activity: 08-09-2014 07:19 PM
  • Join Date: 11-05-2010
  • Referrals: 0


Showing Friends 1 to 8 of 8

Contact Info

Instant Messaging
Send an Instant Message to hughesnp Using...
This Page

All times are GMT -4. The time now is 06:05 AM.

Powered by vBulletin® Copyright ©2000 - 2015, Jelsoft Enterprises Ltd.
SEO by vBSEO 3.6.0