racegrs

Hey im replacing the ECU on my 2001 Rubicon and was wondering if there was a reset procedure I will have to go through to get it to accept properly or just plug the new one in and go?

Thanks

braindead1684

Yes there is after you install the new ECM you need to follow the instructions in the attached PDF.

Attached Files

initializationprocess.pdf (5.2 KB, 34 views)

__________________
87 TRX 200SX
The things just Keeps Going

02 Rubicon 500 4x4
Cycle Country 54" Plow

03 Rancher 350 4x4
(the Wifes ride)

braindead1684

Well the pdf isn't working.

Start Engine and let idle for 30 seconds with bike in neutral.
Move shifter to D (while in D1) and check indicator indicated D
Ride forward approx. 5ft. (slowly)
Move shifter back to N and make sure indicator is back on N.
Turn Key OFF.
Turn Key On While holding UP and DOWN on the ESP Shift switch.
Release UP and DOWN after about 1 second
And immediatly push the ESP keys in this Order. UP, DOWN, UP
The Drive Mode indicator (L D N R) will show a constant -- (if it shows N turn key off and repeat step)
Move Throttle Lever Fully open then closed then Open again.
Release the throttle (within 10 seconds of -- showing on the indicator)
You should hear the control motor sound
The Indicator should change from -- to N

__________________
87 TRX 200SX
The things just Keeps Going

02 Rubicon 500 4x4
Cycle Country 54" Plow

03 Rancher 350 4x4
(the Wifes ride)